Pneumatic ceiling plaster spray gun

Pneumatic plaster made of stainless steel and quality plastic sheet with a brass valve and air connections. Designed for quick and effective spray plastering by a majority of typical plasters and masonry mortars. The use of plastering allows for a significant acceleration of plastering while increasing its quality. Specific placement of the tank facilitates the plastering of the ceilings. The useor is required for the work of the plaster. The tank capacity is over 4.0l, the number of exhaust nozzles-4 average performance-ok 50 m²/1h when working one person weight of the device 2.1 kg required air pressure 4-5 bar required compressor performance 350 l/min for quick and effective plastering spraying by a majority of typical plasters. Requires a compressor connection. The tank placed at a certain angle greatly facilitates the plastering of the ceilings. The inclination of the container prevents the mass from pouring out. Connect the device with a pneumatic cable to the compressor, apply the right amount of mortar/ plaster to the tank, direct holes towards the plastered wall, open the intake valve, spray evenly depending on the needs. After finishing work, dip the plaster tank in water and rinse. Plaster without a pneumatic duct and compressor